Panel Meter

Important Safety Information for Panel Meter
IMPORTANT: These installation instructions are for use by a licensed electrician only. To avoid electrical shock, do not perform any servicing other than ...
Wed, 3 Feb, 2016 at 3:38 PM
Panel Meter Overview
Thank you for choosing the Panel Meter from Jetlun. The Panel Meter is a current transformer (CT) clamp electronic kilowatthour (kWh) meter designed for per...
Thu, 25 Feb, 2016 at 10:34 AM
Hook up diagrams for the Panel Meter
The Panel Meter can support single-phase and three-phase installations. For RD77720/RD71220 Open System Only Three-phase installation One-ph...
Thu, 4 Feb, 2016 at 9:20 PM
Mounting the Panel Meter
Mount the Panel Meter according to the following instructions: For RD77720/RD71220 Open System Model Only Panel Meter installations require a sw...
Thu, 4 Feb, 2016 at 9:23 PM
Connecting the Panel Meter to a Power Source
Always disconnect power– by shutting off circuit breakers or removing fuses–before connecting the power lines to the Panel Meter.   Connect each Panel M...
Thu, 4 Feb, 2016 at 10:06 PM
Connecting Current Transformers (CTs) to the Panel Meter
Only use the CTs provided by Jetlun, as they have been specially calibrated to work with the Jetlun Panel Meter for maximum accuracy. To minimize CT noise, ...
Thu, 4 Feb, 2016 at 10:04 PM
Calibrating CTs to the Panel Meter
Please note that there are two types of Panel Meters: (1) Rated up to 400A; and (2) Rated up to 3000A. The two types of Panel Meters look the same and is on...
Wed, 3 Feb, 2016 at 6:05 PM
How to connect the ZB Panel Meter to a ZigBee Network?
Follow the instructions below. Or, consult the ZB Panel Meter's Quick-Start Guide at the bottom of this article. Connecting to the Sm...
Sun, 7 Feb, 2016 at 5:37 PM
Leaving an existing ZigBee network on the Panel Meter
To leave an existing ZigBee network, press and hold the factory reset button for 8 seconds. The Power/ ZigBee LED will begin flashing orange to indicate it ...
Wed, 3 Feb, 2016 at 6:13 PM
Leaving an existing HomePlug Network on the Panel Meter
To leave an existing HomePlug network, simply change the Network Encryption Key (NEK) of either the Energy Manager or the HP Panel Meter.    To change t...
Thu, 4 Feb, 2016 at 10:16 PM